Page 89 - Microsoft Word - Journal of Physics.doc

is known as a "physical contact" (PC) polish. The curved surface may be polished at an angle, to make an "angled physical contact" (APC) connection. Such connections have higher loss than PC connections, but greatly reduced back reflection, because light that reflects from the angled surface leaks out of the fiber core; the resulting loss in signal strength is known as gap loss. APC fiber ends have low back reflection even when disconnected.

In the mid 1990's fiber optic cable termination was very labor intensive with many different parts per connector, fiber polishing and the need for an oven to bake the epoxy in each connector made terminating fiber optic very hard and labor intensive.

Today many different connectors are on the market and offer an easier less labor intensive way of terminating fiber optic cable.

Some of the most popular connectors have already been polished from the factory and include a gel inside the connector and those two steps help save money on labor especially on large projects. A Cleave (fiber) is made at a required length in order to get as close to the polished piece already inside the connector, with the gel surrounding the point where the two piece meet inside the connector very little light loss is exposed. Here’s an example of a newer style connector being terminated.

Free-space coupling

It is often necessary to align an optical fiber with another optical fiber, or with an optoelectronic device such as a light-emitting diode, a laser diode, or a modulator. This can involve either carefully aligning the fiber and placing it in contact with the device, or can use a lens to allow coupling over an air gap. In some cases the end of the fiber is polished into a curved form that is designed to allow it to act as a lens.

In a laboratory environment, a bare fiber end is coupled using a fiber launch system, which uses a microscope objective lens to focus the light down to a fine point. A precision translation stage (micro-positioning table) is used to move the lens, fiber, or device to

allow the coupling efficiency to be optimized. Fibers with a connector on the end make this process much simpler: the connector is simply plugged into a pre-aligned fiberoptic collimator, which contains a lens that is either accurately positioned with respect to the fiber, or is adjustable. To achieve the best injection efficiency into single-mode fiber, the direction, position, size and divergence of the beam must all be optimized. With good beams, 70 to 90% coupling efficiency can be achieved.

With properly polished single-mode fibers, the emitted beam has an almost perfect Gaussian shape—even in the far field—if a good lens is used. The lens needs to be large enough to support the full numerical aperture of the fiber, and must not introduce aberrations in the beam. Aspheric lenses are typically used.